1.0 Scope This test method uses pressure sensitive tape to determine the adhesion quality of platings, marking inks or paints, and other materials used in conjunction with Printed Boards. 1、范圍本試驗方法使用壓敏膠帶測定鍍層、標記油墨或與印制板一起使用的油漆和其他材料。
4.1 Tape A roll of pressure sensitive tape 3M Brand 600 1/2 inch wide or a tape as described in(CID AA-113). Type 1 Class B, except that the tape may be clear 一卷3M 600壓敏膠帶 1/2英寸寬或如（CID AA-113）所述的3m膠帶。類型1 B類，但磁帶可能是清晰的
5.0 Procedure 流程
5.1 Test Press a strip of pressure sensitive tape, 50mm[2.0 in] minimum in length, firmly across the surface of the test area removing all air entrapment. The time between application and removal of tape shall be less than 1 minute. Remove the tape by a rapid pull force applied approximately perpen dicular(right angle) to the test area. An unused strip of tape must be used for each test.
Originating Task Group Rigid Board T M. Task Group (7-11d)
5.2 Evaluation Visually examine tape and test area for evidence of any portion of the material tested having been removed from the specimen. 評估-目視檢查膠帶和試驗區域是否有證據表明試驗材料的任何部分已從試樣上移除。
5.3 Report The report should note any evidence of material removed by this test. 報告該報告應記錄通過該試驗移除的材料的任何證據。
6.0 Notes 記錄
6.1 If plating overhang breaks off (slivers) and adheres to the tape, it is evidence of overhang but an adhesion failure 如果鍍層懸垂斷裂（碎片）并粘附在 膠帶，它是懸垂的證據，但粘著失效.
6.2 If foreign material (oil, grease, etc. ) is present on the test surface the results may be affected not an adhesion failure 如果測試表面有異物（油、油脂等），則測試結果可能會受到影響，而不是粘著失效
